From: Seb Boulet <SebBoulet@users.noreply.github.com>
Date: Wed, 17 Feb 2021 10:47:42 +0000 (+0000)
Subject: [gpio] Added instructions in case raspi-config is not available  (#9899)
X-Git-Url: https://git.basschouten.com/?a=commitdiff_plain;h=cb9a11858149267b9a2c8dd7fc3a26b14b2e439a;p=openhab-addons.git

[gpio] Added instructions in case raspi-config is not available  (#9899)

Signed-off-by: Seb Boulet <SebBoulet@users.noreply.github.com>
---

diff --git a/bundles/org.openhab.binding.gpio/README.md b/bundles/org.openhab.binding.gpio/README.md
index e935a735f7..622cf48358 100644
--- a/bundles/org.openhab.binding.gpio/README.md
+++ b/bundles/org.openhab.binding.gpio/README.md
@@ -22,12 +22,25 @@ sudo raspi-config
 
 -> Interfacing Options --> Remote GPIO --> YES --> OK --> Finish
 
+Note: if you are setting this up on a Raspberry Pi without `raspi-config` you can create the service config file manually:
+
+```
+sudo mkdir -p /etc/systemd/system/pigpiod.service.d/
+sudo nano /etc/systemd/system/pigpiod.service.d/public.conf
+```
+      [Service]
+      ExecStart=
+      ExecStart=/usr/bin/pigpiod
+```
+sudo systemctl daemon-reload
+```
+Now that Remote GPIO is enabled, get the daemon going:
 ```
 sudo systemctl enable pigpiod 
 sudo systemctl start pigpiod
 ```
 
-Set `host` to the address of the pi and the `port` to the port of pigpio (default: 8888).
+In openHAB, set `host` to the address of the pi and the `port` to the port of pigpio (default: 8888).
 
 ## Channels